e 906 | 6/8
Cleaning and maintaining the e 906
Cleaning and maintaining the e 906
CAUTION
LIQUIDS CAN DAMAGE THE ELECTRONICS OF THE PRODUCT!
Liquids entering the housing of the product can cause a short-circuit and damage the electronics.
Keep all liquids away from the product.
Do not use any solvents or cleansing agents.
Disconnect the products from the power supply system and remove rechargeable batteries and
batteries before you begin cleaning.
Clean all products only with a soft, dry cloth.
Specifications
Transducer principle dynamic
Frequency response 40 - 18,000 Hz
Pick-up pattern super-cardioid
Sensitivity (free field, no load) 2,2 mV/Pa
Nominal impedance (at 1 kHz) 350 Ω
Min. terminating impedance 1 kΩ
Connector XLR-3
Dimensions 55 x 34 x 134 mm
Weight 140 g
To Next Page
Loading...
