Need help?Do you have a question about the Sennheiser HMD 280 PRO and is the answer not in the manual?
General| Type | Closed-back, dynamic |
|---|---|
| Impedance | 64 Ohms |
| Sound Pressure Level | 113 dB |
| Ear Coupling | Circumaural |
| Microphone Type | Dynamic |
| Cable Length | 3 m |
| Connector | 3.5 mm stereo jack plug (1/8") with 6.3 mm (1/4") adapter |
Accurate, linear sound reproduction for critical monitoring applications, low impedance headset (64 Ω).
High impedance variant (300 Ω) of the HMD 280 PRO headset.
Single-sided variant of the HMD 280 PRO headset.
High impedance variant (300 Ω) of the HMD 281 PRO headset.
Adjust the headband via its snap-in locking mechanism for good transmission quality and comfort.
Allows wearing the microphone boom on either side of the mouth for optimal positioning.
Place microphone at corner of mouth, approx. 2 cm distance, to minimize pop noise.
Remove old ear cushions by pulling them away from earcups and slide new ones on.
Detach old padding using Ziploc strips, then attach new padding, overlapping strips.
Detailed steps for removing the old cable and installing a new one, including connector and strain relief.
Microphone replacement must be performed by a Sennheiser service partner if defective.
To Next Page
