Sennheiser MD 441 Product Sheet

Features—Benets
• Excellent feedback rejection
• Excellent sound quality
• Spring capsule mounting—low sensitivity to handling noise
• Hum compensating coil—reduces electrical interference
• Five position bass roll-off switch—compensates for proximity effect
• Brilliance (treble boost) switch—added speech intelligibility
• Integral pop lter
Technical Data
dioidrac-repusnrettap pu-kciP
zH 000,02–03esnopser ycneuqerF
Sensitivity (free eld, no load) (1 kHz) 1.8 mV/Pa ± 2 dB
002 ecnadepmi lanimoN Ω
Min. terminating impedance 1 k
4.1 x 3.1 x 36.01 sehcni ni snoisnemiD
zo 78.51.xorppa thgieW
MD 441 U Microphone
The MD 441 U is a microphone of exceptional quality: its acoustic properties come as close
as possible to those of a condenser microphone. Accurate signal response and low distortion
are ensured, even with the highest sound pressure levels. Surface: all metal body with black
simulated leather nish, sound inlet basket: nickel plated
Optional Accessories
144 AZMretpada dnats gnikcoL
21' XLR microphone adapter MC21N
144 WZM dleihsdniw maoF
Optional Accessories
144 QZMretpada dnats elbixelF 1
Architect’s Specications
Super-cardioid studio microphone, hum compensating coil, ve position bass control, brilliance
switch, integral pop lter, frequency response 30–20,000 Hz, sensitivity (free eld, no load)
1.8 mV/Pa ± 2 dB at 1 kHz, nominal impedance 200 Ω, min. terminating impedance 1 k,
dimensions 270 x 33 x 36 mm, weight approx. 450 g.
MD 441 U
MD 441 U
CBinder - MIcrophones.indd 49 11/11/08 2:25:06 PM

Sennheiser MD 441 Specifications

General

Transducer Type	Dynamic
Polar Pattern	Supercardioid
Frequency Response	30 Hz - 20 kHz
Impedance	200 ohms
Connector	XLR-3
Minimum Terminating Impedance	1 kOhm
Weight	450 g
Length	270 mm