Using the RS 5200
RS 5200 | 25
1. Switch your audio source on and select a program where speech
is foregrounded.
2. Put the stethoset receiver on and make sure that only this
receiver is connected to the transmitter. Otherwise, a hearing
profile cannot be adjusted.
3. Use the
L and R buttons on the transmitter to adjust the balance
(see page 22). This ensures that each subsequently selected
hearing profile is perfectly matched to your left/right balance set-
ting.
4. Press the Hearing profile button on the transmitter for 2 seconds
to select the next hearing profile.
Press the button again for 2 seconds to switch to the next hearing
profile.
5. Test which of the hearing profiles (1, 2 or 3) gives you the best
sound quality and helps you to hear best.
Your individual hearing profile is adjusted and saved on the ste-
thoset receiver.
To Next Page
Loading...
