ST-200 aQua Operator’s Manual
Press 3
PRINTER
STATUS : ON
Y→ON N→OFF
Press Y to ON, press N to OFF the printer status
SETUP MENU
1.ANALYZE TYPE
2.DATE/TIME
3.PRINTER
4.PRINT-PARAMETERS
5.PRINT-mV
6.PATIENT-ID
Press 4
↓
PRINT PARAMETERS
1.Na
2.K
3.Cl
4.iCa
5.Li
Y→ Next N→ Exit
If your required parameter is present in this screen then select the parameter by pressing
appropriate number, if not then press Y button to see more parameters.
↓
PRINT PARAMETERS
6.pH
7.All
N→ Exit
Press corresponding number for parameters details which to be analyzed and printed
And press N to exit.
Print –mV:
If user don’t want to print mill volts (mV) of CAL A, CAL B but only wants results
then Print –mV can be deselected.
SETUP MENU
1.ANALYZE TYPE
2.DATE/TIME
3.PRINTER
4.PRINT-PARAMETERS
5.PRINT-mV
6.PATIENT-ID
Press 5
↓
PRINT – mV
STATUS : ON
Y→ON N→OFF
Press Y to ON, press N to OFF the PRINT – mV status
To Next Page