Sensitech TempTale RF User Manual

3
All TempTale
®
RF monitors can be programmed with a custom Start-up delay, measurement
interval and alarm settings which have been pre-determined by the customer.
Starting a TempTale
®
RF Monitor
• Press and release the START button. (1)
• The “Sunshine” icon appears in the upper left corner of the display (2).
• The TempTale RF will begin to record data after the start-up delay has passed.
To Mark an Important Event (“Date Stamp”)
• TempTale RF monitors provide an option to “Date Stamp” or mark an important event at
any time during the monitoring cycle that will be visible when viewing the data. The mark
is displayed as an arrow when viewing the graph and shown in italics when viewing the
tabular data.
• To mark a graph while the monitor is recording, press and release the START button.
• The “arrow” icon will appear temporarily in the lower left corner and the temperature
history will appear on the display. Data appears as follows:
1. Average temperature of Primary (Ambient) Sensor Readings
2. Highest temperature recorded at Primary Sensor
3. Total time above high temperature limit of Primary Sensor
4. Lowest temperature recorded at Primary Sensor
5. Total time below low temperature limit of Primary Sensor
Alarm
When the TempTale RF monitor is exposed to a temperature outside a pre-programmed limit and time threshold, an
“Alarm bell” will appear in the lower right corner of the LCD display.
Stopping a TempTale RF Monitor
Press and hold (1 to 3 seconds) the STOP button until the “Stop sign” icon appears in the upper right corner of the
LCD display.
1
2
Displayed Information
1. Recording
2. Marked point
3. Temperature data
4. Stopped recording
5. Limits exceeded
1 4
3
2 5

Sensitech TempTale RF Specifications

General

Brand	Sensitech
Model	TempTale RF
Category	Measuring Instruments
Language	English