To Next Page
J
Jessica SpenceJul 25, 2025
What to do if it is not possible to configure Sensopart Accessories sensor via the operating keys?
- AAngela PetersenJul 25, 2025
If you cannot configure the Sensopart Accessories sensor using the operating keys, it might be due to several reasons: * The electrical lock is active because PIN 8 is on high. In this case, disconnect PIN 8. * The key lock command was activated via the RS485 interface. Cancel the key lock function via the interface. * The key was not pressed long enough (less than 3 seconds), and the configuration mode was not activated due to the time lock. Press the key for more than 3 seconds.
General
