What to do if the Sensopart FT 50 RLA-70 Accessories sensor is not found by the software after connection?
If the Sensopart Accessories sensor is not found by the software after connection, it might be programmed as a master or slave. Reset the sensor to factory settings via the control panel.
Why does the Sensopart Accessories sensor no longer react to the program after activating fast measurement value?
If the Sensopart Accessories sensor no longer reacts to the program after activating fast measurement value, it may be because PIN 3 (Q1) = +UB or Q1 was set to high via software. You can set Q1 back to low to make settings possible again. Alternatively, disconnect the power supply and restart the sensor to make it operational again.
What to do if the Sensopart FT 50 RLA-70 sensor does not switch to set-up mode?
If the Sensopart Accessories sensor does not switch to set-up mode via the control panel, it might be simultaneously operated via the interface. Try disconnecting the serial interface.
Why is the master-slave mode not functioning on my Sensopart Accessories?
If the master-slave mode for Sensopart Accessories does not function and LED C is only lit on one sensor, it could be due to one sensor not being in the correct mode or not having function no. 27. Reprogram the sensor whose LED is not lit, or use the sensor that does not have function 27 as the master.
General| Shape | Round |
|---|---|
| Diameter | 50 mm |
| Model | FT 50 RLA-70 |
| Operating voltage | 10-30 V DC |
| Output type | PNP |
| Switching distance | 70 mm |
| Housing material | Plastic |
| Protection class | IP67 |
To Next Page
