EasyManua.ls Logo

Sentern JC-82 - Troubleshooting and Wiring; Troubleshooting Guide; Wiring Diagram

Sentern JC-82
5 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P
OSSIBLE PROBLEMS WITH YOUR APPLIANCE
You can solve many common problems easily. Try the suggestions below to see if you can solve the
problem before contacting customer service.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Unit does not operate.
Not plugged in.
The circuit breaker tripped
or a blown fuse.
Turns on and off frequently.
The room temperature is higher than normal.
A large amount of food has been stored in the
unit.
The door has been opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The unit does not have the correct clearances.
Vibrations.
Make sure the unit is placed on level ground.
The unit seems to make too much noise.
The rattling noise may come from the flow of
the wine cooler, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of wine cooler in
your unit.
Contraction and expansion of the inside walls
may cause popping and cracking noise.
The unit is not level.
The door will not close properly.
The unit is not level.
The door was reversed and not properly installed.
The gasket is dirty or bent.
The shelves, bins, or baskets are out of position.
WIRING DIAGRAM