SolaSmart™ Plus Installation Guide
Version 1.1 – Mar 2012 Page 2
BEFORE YOU BEGIN INSTALLATION, CONTINUED
Assemble the
Tools You
Will Need
You will need the following tools to install the SolaSmart™:
Philips1 screwdriver for lid screws.
Pozi 2 screwdriver for mounting screws.
NOTE: These tools are needed to mount the SolaSmart™ only, and other
tools may be needed for the remainder of the installation including the
sensors.
READ THESE SAFETY PRECAUTIONS and LIMIT OF LIABILITY BEFORE YOU BEGIN
The following pages contain instructions for qualified personnel only. They involve potentially
hazardous adjustments and high voltage mains wiring information.
General
Safety
Precautions
The following general safety precautions should be noted:
This installation guide is for the installation of SolaSmart
TM
The complete installation should be checked at least annually for damage or
malfunction.
Controllers only
and is not an installation guide for any other part.
All servicing must be carried out by an authorised service agent only.
All aspects of the installation must comply with local electrical and plumbing
regulations (and any special solar hot water regulations).
Continued on next page
To Next Page
Loading...
Need help?
General