SolaSmart™ Plus Installation Guide
Version 1.1 – Mar 2012 Page 3
BEFORE YOU BEGIN INSTALLATION, CONTINUED
Installation
Precautions
Installers need to ensure the following:
The controller must be installed away from water sources such as rain,
leaking pipes, or wet floors; and must not be installed in damp areas like
bathrooms. The controller must have a waterproof enclosure if it is installed
outside.
Make sure the controller is installed away from direct sunlight, flammable
liquids or radiant heat sources.
Power leads must face directly down, not sideways or upwards.
Ensure the controller is in a safe environment for users to inspect display
panel.
Follow instructions carefully when mounting sensors. Incorrect sensor
mounting can lead to a poorly controlled solar hot water system with safety
issues (e.g. overheating; over pressure damage to the plumbing; freezing
damage to the solar collector).
The unit settings are factory programmed to optimise efficiency and safety.
Alteration of the programmed values can lead to dangerous conditions and/or
damage to parts of the solar hot water system.
Dangerous Voltages may be present. The SolaSmart
TM
Protective enclosure must only be opened by qualified personnel.
has no user
serviceable parts.
Remove ALL power sources before removing protective cover.
Continued on next page
To Next Page
Loading...
Need help?
General