Senztek SolaSmart Plus User Manual

SolaSmart Plus™ User Guide
Version 2.0 – September 2013 Page 1
T
HE DISPLAY PANEL
CAUTION:
The SolaSmart-Plus
TM
Dangerous Voltages present inside enclosure during operation.
has no user serviceable parts.
Protective enclosure must only be opened by qualified personnel.
Remove ALL power sources before removing protective cover.
 Pressing the NEXT button will cycle through an extended range of screens including the
time, what heating profile the controller is using, what speed the pump is running at (%) and
diagnostics. These are explained later in the manual.
 The 3 sensor temperatures will cycle through Roof – Tank – Inlet. Indicated by the single
dot next to label on the display.
 The 3 sensor temperatures will cycle through Roof – Tank – Inlet. Indicated by the single
dot next to label on the display.
The CONTROLLER OK
light is on when the
controller is operating
correctly.
The PUMP light comes on when the
pump is on (in normal or FROST
operation or when the PUMP button is
pressed).
For Dual Element model:
The HWC2 light comes on when
upper element is on.
The HWC1 light comes on when
element is on.
- (HWC) Button
Press to decrease guaranteed
stored hot water reserve (Comfort
level).
Press ENTER button and this button
together to initiate a one off Boost of
the hot water tank. Press same
buttons again to cancel.
The SENSORS OK light is
on when the sensors are
operating correctly.
Light off; check Roof
sensor.
Light flashing; check Tank
sensors.
+ (PUMP) Button
Press to increase guaranteed stored hot water
reserve (Comfort level).
.

Senztek SolaSmart Plus Specifications

General

Brand	Senztek
Model	SolaSmart Plus
Category	Controller
Language	English