HD3U Ultra-Wide Camera
Copyright © Safe Fleet 2018 | All rights reserved | Part #: 700-1130 R1
Quick Installation Guide
WARNING: Harness Compatibility
This camera requires a special Analog High Denition (AHD) harness - as indicated by a blue
band in front of the connectors. Note that a standard harness may appear to work on a small
analog screen, but the image will be signicantly degraded during subsequent playback.
Installation Kit Contents
The kit includes the following components:
• 1 HD3U camera with pre-inserted grommet on
connector cable
• 1 Mounting bracket
• 2 x #10 ¾” self-drilling screws
• 1 Torx T10 security key
• 1 drilling template
• 1 Quick Installation Guide
Power Consumption Max 4.2W (IR on)
Operating Voltage Range 9 to 14 VDC (powered by recorder)
Operating Temperature Range -4 to 122°F (-20 to 50°C)
Field of View (FOV) H: 171 V: 88
Resolution 1080p
Infrared LED Lamps 4 high efciency LEDs
Minimum Illumination B&W, IR LEDs on: 0 lux
Enclosure Size Height: 2.1” (53.55 mm)
Width: 2.7" (68.6 mm)
Depth (with bracket): 2.5" (63.74 mm)
Enclosure Material Die-cast aluminum (powder-coated)
Environmental Rating IP67
Bracket Material SUS304
Dome Polycarbonate
Connector Cable Length 12” (30 cm)
Weight 0.39 lbs (177 g)
Specications
Step 1: Choose Camera Location
The mounting location must meet the following requirements:
• a solid surface (to minimize vibration)
• away from access panels, hatches, or doors which may block the camera view
• away from heat sources
Cameras are usually installed with cabling running inside wall panels.
This guide applies to the HD3U01ANXX camera model series.
Routine Maintenance
Most liquid cleaners or grafti gel can be used to clean your camera enclosure. Do not use
abrasive cleaners that can scratch the window and reduce visibility of the camera.
Service
If your HD3U series Ultra-Wide Camera is to be returned for service, please call toll free
1.877.630.7366, or 1.844.899.7366, and provide the model and/or serial# of your unit. Ask for
a Return Merchandise Authorization (RMA) number. An RMA# allows the Service Technicians to
better track your product when it comes in for service. Please show the RMA# on the outside of
the package. ANY PRODUCT SENT WITHOUT AN RMA# MAY BE REFUSED.
Technical Support
Email: service@seon.com
Phone: 1.877.630.7366
Documentation
Additional copies of this guide, along with other supporting docu-
mentation can be found on the SafeFleet Community:
https://community.seon.com/documents/
Step 2: Choose Mounting Orientation
The HD3U can be mounted in two orientations: "ceiling mount" (bracket arms angled down from
the mounting surface), or "wall mount" (bracket arms angled up):
Ceiling Mount
Wall Mount
Mounting
Bracket
To select an orientation, consider the mounting surface and range of motion (camera tilt and
bracket wall pivot or ceiling pan) that provides the required eld of view (see Step 3, below). The
most common position will be ceiling mount, with the camera tilted downward (approximately
45 degrees below the horizon).
To Next Page
Need help?
General
