Need help?Do you have a question about the SEPTENTRIO mosaic-X5 and is the answer not in the manual?
Overview of the mosaic GNSS module's capabilities and design.
Maximum environmental and electrical conditions.
Electrical specifications under normal operating parameters.
Power supply voltage, current, and input requirements.
Input/output voltage levels, current drive, and capacitance.
Detailed description of power supply pins and voltage levels.
Details on antenna input connections and electrical specifications.
Specifications for the primary antenna input.
Description of serial communication ports and flow control.
Configuration and usage of the USB device interface.
Interface for external SD memory cards and data logging.
Instructions for using the SD card for data logging.
Control mechanisms for entering standby mode.
Recommended minimal design for module integration.
Guidelines for PCB layout for optimal performance.
Strategies to minimize interference between signals.
Handling guidelines to prevent electrostatic discharge damage.
Guidelines and recommendations for soldering the module.
Recommended temperature profile for reflow soldering.
Methods and voltage ranges for powering the DevKit.
Methods for powering the mosaic-go evaluation kit.
Details on adjusting RF gain for the dual-antenna mosaic-H module.
Overview of the mosaic GNSS module's capabilities and design.
Maximum environmental and electrical conditions.
Electrical specifications under normal operating parameters.
Power supply voltage, current, and input requirements.
Input/output voltage levels, current drive, and capacitance.
Detailed description of power supply pins and voltage levels.
Details on antenna input connections and electrical specifications.
Specifications for the primary antenna input.
Description of serial communication ports and flow control.
Configuration and usage of the USB device interface.
Interface for external SD memory cards and data logging.
Instructions for using the SD card for data logging.
Control mechanisms for entering standby mode.
Recommended minimal design for module integration.
Guidelines for PCB layout for optimal performance.
Strategies to minimize interference between signals.
Handling guidelines to prevent electrostatic discharge damage.
Guidelines and recommendations for soldering the module.
Recommended temperature profile for reflow soldering.
Methods and voltage ranges for powering the DevKit.
Methods for powering the mosaic-go evaluation kit.
Details on adjusting RF gain for the dual-antenna mosaic-H module.
General| Type | GNSS Receiver |
|---|---|
| Power Supply | 9-36 V DC |
| Operating Temperature | -40 °C to +85 °C |
| Update Rate | Up to 100 Hz |
| Frequency Bands | L1, L2, L5 |
| Supported GNSS | GPS, GLONASS, Galileo, BeiDou, QZSS |
| Data Output Format | NMEA, RTCM |
| Protocols | TCP/IP, NTRIP, FTP, HTTP |
| Communication Interfaces | Ethernet, Serial, USB |
To Next Page
