SereneLife SLSFE11 User Manual

SLSFE11
Portable Electronic Safe Box
INSTRUCTIONS
1. TO PROGRAM AND CHANGE
THE USER CODE
a.
First, open the door of your safe,
without turning the rotary knob before
you start to program your safe.
Remove the battery compartment cover on the back of the door and
place the batteries (4x1.5 batteries type AA) into the battery holder
correctly. (Batteries included inside the safe).
b. While the door is open, press the button behind the door. The yellow
light will be on with a short beep. Please input the user code (from 3-8
digits) using any number from “0” to “9” within 30 seconds, then press “E”
to conrm it.
c. To change the user code, please use the same procedures as above.
2. TO OPEN THE SAFE
Input the user code you programmed, then press ”E”. The green light will
be on. Please turn the knob within 5 seconds and pull out to open the
safe. If a wrong digit is input, you can press “C” to cancel it.
Note: With each press the yellow light will ash with a short beep,
indicating that the micro processor conrmed it. If the yellow light keeps on
ashing with the beep, it means the code is wrong. Inputting the wrong
code three times will result in the micro processor refusing to accept the
input for 20 seconds. If you press the wrong code three times again, the
micro processor will refuse to accept input for 5 minutes.
3. TO CLOSE THE SAFE
Close the door and turn the knob counter-clockwise to lock the safe.
www.SereneLifeHome.com

SereneLife SLSFE11 Specifications

General

Model	SLSFE11
Category	Safes
Material	Steel
Color	Black
Emergency Key	Yes
Battery	4 x AA (not included)
Type	Portable Electronic Safe

Summary

Program and Change User Code

Programming the User Code

Open safe, insert batteries, press button, input 3-8 digit code, press 'E' to confirm.

Changing the User Code

Use the same procedures as programming to change the existing user code.

Open the Safe

Opening Procedure

Input programmed code, press 'E', turn knob within 5 seconds, pull door open.

Error Handling and Notes

Yellow light confirms input. Flashing means wrong code. Multiple errors cause temporary lockout.

Close the Safe

Closing Procedure

Close the door and turn the knob counter-clockwise to lock the safe.

Use Override Keys

Override Key Operation

Locate keyhole behind cover, insert key, turn anti-clockwise to open.

Replace Batteries

Battery Replacement Indicator

Red and green lights indicate low batteries. Always use alkaline batteries.

Install the Safe

Mounting Options

Safe can be secured to floor, wall, or cupboard using provided expansion bolts.

Important Warnings

Key and Code Management

Store override keys separately. Supplier not liable for lost keys/codes or weak batteries.