Serialio BlueSnapXP - Page 17

BlueSnap Commands Version 4.81SIO, 1/20/2016 Page 17 of
27
Cedar Park, TX, USA • (512) 994-3630 • sales@serialio.com www.serialio.com
S7,<1,0> - 7 bit data mode enable/disable 0= disabled
SA,<1,0> - Authentication enable/disable 0= disabled
SB,<timer> - Send BREAK Not Applicable
SC,<hex word> - Service Class 0x0000= unknown
SD,<hex word> - Device Class 0x1F00= undefined
SE,<1,0> - Encryption enable/disable 0=disabled
SF,1 - Factory Defaults
SI,<hex word> - Inquiry Scan window 0x0200
SJ,<hex word> - Page Scan window 0x0200
SL,<E,O,N> - Parity N=None
SM,<0,1,2,3> - Mode (0=Slave, 1=mstr,2=trig, 3=auto) 0=Slave
SN,<text> - Name BlueSnap
SO,<text> - Connect/Disconnect Status String NULL= no status string
SP,<text> - Pin Code 1234
SR,<adr> - Remote Address (SR,Z to remove) NONE SET
SS,<text> - Service Name SPP
ST,<num> - Config Timer 60 seconds
SU,<rate> - Baudrate 115K
SW,<hex> - SNIFF rate 0x0000=disabled
SX,<1,0> - Bonding 0=disabled
SZ,<num> - Raw Baudrate
S-,<name> - Serialized Name BlueSnap-xxxx
S?,<1,0> - Role Switch 0=disabled
S~,<1,0> - Profile setting 0=SPP, 1=DCE, 2=DTE, 3=MDM 0 = SPP
S~,<6> - Profile setting 6=HID 6 = HID
S+,<num> - Sleep timer 180 seconds
GET, DISPLAY COMMANDS
D - Basic Settings
E - Extended Settings
O - Other Settings
G<X> - Stored setting
H - Help
GB - BT Address
GK - Connection Status
G& - I/O Ports
V - Firmware version
ACTION COMMANDS
$$$ - Enter Command Mode
--- - Exit Command Mode
+ - Local echo. Toggle local echo of RX characters in command mode. (default is off)
C,<address> - Connect, optional address, if no address, use stored remote address.
CT - Connect Timer,