STEP 5
Locate and connect the
foot massage motor and
foot motor into the control
box in respective labeled
ports.
STEP 6
Divided King Setup is now complete! Return to page “ 8” Step
“9” to complete the base setup.
Locate and connect the LED
light cable to the LED controller
box as seen here:
The wires may be placed
inside the wire management
(rubber conduit) for a clean
appearance.
STEP 4
Attach the legs by screwing them into the leg bolts at the center
connection points and all four corners as seen here:
Fig. C
Fig. D
V002_12/2015
To Previous Page
Loading...
