9
installation guide
STEP 7
STEP 8
STEP 9
STEP 10
Carefully ip the base over onto its legs.
Important: Always use two people when setting up, moving or
ipping the base. Do not drag across the oor. Do not rest frame on
its side, excessive pressure may damage the legs.
Setup is now complete! Test all functions on remote.
Insert each end of the mattress retainer bar into the holes at
the foot of the base. Make sure the bar is secured.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
WARNING
Always unplug the base from the electrical outlet before servicing any
part of the base. To reduce risk of electric shock, unplug the base before
cleaning. To safely disconnect, ensure the base is in a flat position with all
motors o, and unplug from power source.
Plug the base into a power source. A surge protector is
strongly recommended.
Ensure batteries are correctly installed in the
back of the remote.
Quickly test functions to verify proper setup
before placing mattress on base. Press FLAT
to return the base to a at position.
To Next Page
Loading...
