Sertain S4540 - 3.12 Auto Chair Function; 3.13 Auto Flat Function

To Next Page

To Previous Page

DO NOT USE CHAIR UNTIL YOU HAVE FULLY READ THE INSTRUCTIONS

3.12 Auto Chair Function - (Models with this feature)

WARNING:

Before using this function, make sure it is safe to do so. Make sure no

item (equipment, persons, etc) obstruct the path of any moving part

of the chair during this function. Warn all persons before actioning

this function.

This is an automatic chair position function – to operate, press and

hold the ‘Auto Chair’ button, as indicated in Figure 12 (bottom right

corner of handset button series). While holding this button (from

any existing position), the chair will operate the backrest, seat tilt,

hi-low, and leg rest functions simultaneously until the chair position

is reached (Hi-Lo will be at its lowest height). Once this position is

reached and all motors have stopped then release the button.

Release of the button before the chair has reached the pre-set sitting

position, will stop all functions wherever they are at the time. The

chair will not continue to operate automatically. Resuming pressure

on the button will continue the function.

3.13 Auto Flat Function (this is not a CPR facility) - (Models

with this feature)

WARNING:

Before using this function, make sure it is safe to do so. Make sure no

item (equipment, persons, etc) obstructs the path of any moving part

of the chair during this function. Warn all persons before actioning

this function.

This is an automatic Bed / Lay Flat position function – to operate,

press and hold the ‘Auto Flat’ button, as indicated in Figure 13

(bottom left corner of handset button series). While holding this

button (from any existing position), the chair will operate the

backrest, seat tilt, hi-low, and leg rest functions simultaneously until

the bed/lay at position is reached (Hi-Lo will be at its lowest height).

Once this position is reached and all motors have stopped then

release the button.

Release of the button before the chair has reached the pre-set bed/

lay at position, will stop all functions wherever they are at the time.

The chair will not continue to operate automatically. Resuming

pressure on the button will continue the function.

Operating Instructions

Figure 12

Figure 13