What to do if my SERVIS WD1496FGW Washer/Dryer does not receive water?
If your SERVIS Washer Dryer does not receive water, it may be because the water inlet filters are blocked. Clean the water inlet filters. See page 63 for detailed instructions.
How to fix excessive foam in the detergent drawer of my SERVIS WD1496FGW Washer/Dryer?
If you see excessive foam in the detergent drawer, it may be because the wrong detergent has been used. Only use detergents produced for automatic Washer Dryers.
Why is my SERVIS Washer/Dryer not draining water?
There are several reasons why your SERVIS Washer/Dryer might not be draining water: * The drain hose could be bent, twisted, kinked, or trapped. Inspect the hose and straighten any obstructions. * The pump filter might be obstructed. In this case you should clean the pump filter. * Your laundry might be too tightly packed in the drum. Make sure your laundry is spread out.
What to do if my SERVIS Washer/Dryer does not operate?
If your SERVIS Washer/Dryer isn't operating, consider these possibilities: * Ensure it's plugged in and switched on at the mains. * Check that the programme dial is not in the off position; select a programme. * Confirm that the door is properly shut, listening for a ‘click’ and ‘beep’.
Why is my SERVIS Washer/Dryer vibrating so much?
Excessive vibration in your SERVIS Washer/Dryer can be due to: * Incorrectly adjusted feet. You should adjust the feet of your machine. * Transit bolts not being removed. Make sure to remove the transit bolts.
Why is my laundry still damp after drying in my SERVIS WD1496FGW?
If your laundry remains damp after drying, it might be because: * The appropriate drying programme wasn't selected. Choose a programme suitable for your laundry. * The maximum load capacity for the selected programme was exceeded. Please refer to the programme tables on pages 37 to 48.
What to do if the washing result is not as expected with my SERVIS WD1496FGW Washer/Dryer?
If your washing result isn't as expected, consider these points: * Your laundry might be too dirty for the selected programme. Use the information on pages 37 and 48 to select the most appropriate programme. * Not enough detergent was used. Use the amount of detergent as instructed on the packaging. * There is too much laundry in your Washer Dryer. Check that the maximum capacity of your Washer Dryer is not exceeded.
What to do if the load detection system on the screen of my SERVIS WD1496FGW Washer/Dryer does not work?
If the load detection system isn't working, it may be because laundry is placed in the Washer Dryer without choosing a washing or drying programme. Remove the laundry from your Washer Dryer. Switch the programme dial to STOP, reselect the desired programme. Load the laundry in the machine and run.
Why does the water from my SERVIS Washer/Dryer drain as soon as it fills?
If the water drains immediately after filling, the end of the water drain hose may be too low. Check that the drain hose is at a suitable height. See page 15 for more information.
Why doesn't the spin cycle take place in my SERVIS WD1496FGW Washer/Dryer?
If the spin cycle doesn't take place, the in-built sensor may have prevented your Washer Dryer from operating with an out of balance load. Avoid small wash loads containing items that could become heavy through water absorption.
Lists included items and provides crucial safety precautions before operating.
Essential requirements and considerations for installing the Washer Dryer safely.
Instructions on how to remove transit bolts before first use and how to refit them.
Guides on how to level the Washer Dryer using its adjustable feet.
Instructions for connecting the Washer Dryer to the cold water supply.
Further steps on connecting the water supply hose to the tap.
Instructions on how to connect the drain hose to the household drainage system.
Checks before first wash and how to run a drum cleaning cycle.
Guidance on adding detergent and consequences of incorrect usage.
Steps to select programmes and adjust temperature/spin speed.
Options for drying laundry after a wash (Cupboard, Hanger, Iron Dry).
Guidance on choosing temperatures and spin speeds for optimal washing.
Routine maintenance tasks to ensure optimal operation of the Washer Dryer.
Information on cleaning water inlet filters to ensure water flow.
Guidance on cleaning the pump filter to prolong pump life.
Step-by-step instructions for cleaning the pump filter.
Explains international washing symbols found on garment labels.
General troubleshooting guide for common operational issues and their solutions.
Explains the fault detection system and common error codes like NO WATER, OVERFLOW.
General| Washing Capacity | 9 kg |
|---|---|
| Drying Capacity | 6 kg |
| Maximum Spin Speed | 1400 rpm |
| Spin Speed | 1400 RPM |
| Color | White |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
To Next Page
