10
USER MANUAL
NOTE: If lime and mineral deposits are still present in the water pan, repeat this procedure and increase the amount
of time the de-liming mixture stands in the water tank.
Cleaning and Installation of
Rotary Shelves:
1. Turn off the unit and unplug it, allow the unit up to 30
minutes to cool down. NOTE: Opening the glass door(s)
can help speed up the cooldown process.
2. Loosen top nut and bolt of the rotary shelf and remove.
3. Remove the rotary shelf from the heated cabinet and
handwash with warm soapy water and air dry.
4. Place shelf back into unit, securing using the nut and bolt.
Cleaning and Installation of
Non-Rotary Shelves:
1. Turn off the unit and unplug it, allow the unit up to 30
minutes to cool down. NOTE: Opening the glass door(s)
can help speed up the cooldown process.
2. Lift the shelf from the clips.
3. Remove the shelves from the heated cabinet and
handwash with warm soapy water and air dry.
4. Place shelves back into unit on clips.
Removing Lime and Mineral Deposits:
1. Turn off the unit, unplug, and allow the unit to cooldown.
2. After the unit has cooled, remove and empty the water pan.
3. Fill the water pan with a mixture of 70% water and 30% white vinegar to a level where it covers the lime and
mineral deposits.
4. Plug in and turn on the unit to the highest temperature and humidity settings. Allow the unit to run for 30 minutes.
5. Turn off the unit and unplug the power cord, allow unit to cool.
6. Allow the water pan to stand with the deliming solution for at least two hours (the time required will vary
depending on the amount of deposits in the water tank).
7. Using a bucket or bowl, drain the unit to empty the deliming solution from the water tank.
8. Continue to fill and drain the water tank with clean water until the deliming solution is flushed out and the water
flows through clear through the drain valve.
9. Replace the rack, plug unit in and refill the water tank with up to 1 gallon of distilled water.
Clutch
Bolt
Nut
To Next Page
Loading...