5
USER MANUAL
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical receptacle of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified electrician to determine and install proper voltage and size
electrical receptacle.
• Installation must conform to all local electrical codes, and where applicable must be installed by a qualified
electrician. Installation by unqualified personnel will void unit warranty and may lead to electric shock or burn, as
well as damage to unit and/or its surroundings.
• Turn OFF power switch, unplug power cord/turn off power at circuit breaker, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not waterproof. Do not operate if unit has been submerged or
saturated with water.
• Unit is not weatherproof. Locate unit indoors where ambient air temperature is a minimum of 70°F (21°C).
• Do not clean unit when it is energized or hot.
• Do not steam clean or use excessive water on the unit.
• This unit is not “jet-proof” construction. Do not use jetclean spray to clean this unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not allow liquids to spill into the unit.
• This unit must be serviced by qualified personnel only. Service by unqualified personnel may lead to electric
shock or burn.
FIRE HAZARD:
• Locate unit a minimum of 12" (25 mm) from combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
• Do not use harsh chemicals such as bleach (or cleaners containing bleach), oven cleaners, or flammable cleaning
solutions to clean this unit.
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Use caution when touching these areas.
• Use caution when opening doors. Hot air escapes when door is open.
To Next Page
Loading...