CDHD2
30 Operator Panel (HMI)
Move Incremental - Distance
Move Incremental - distance
MOVEINC {distance} {velocity}
Sets the distance argument. Command uses velocity value set by JOGSPD1.
Display: incnn
Press: Long Shift
Display: flashing 0
Press: (for example) Set a value of 2 (revolutions)
Press: Long Shift
Display: incnn (during movement)
Display: done
(or an error code)
Note value of movement = revolution, counts, degrees
Sets distance for movement. Speed is set according JOGSPD1
Home
Display: honne
Press: Shift
Display: Flashing 0. in digit 1
Press: Set the value of a homing type
Press: Long Shift
Press: Long Shift
Display: (indicates homing progress in a % number)
Display: done
(or an error code)
To Next Page
Loading...