IMPORTANT:
●
If a DC extension cable is required we recommended use of a 6mm dia. (AWG11) 4.58mm Twin
Sheath Two Core cable with direct connection to the positive and negative battery terminals with
15A inline fuse protection.
●
The Fridge/Freezer is equipped with an electronic control system that will prevent polarity reversal.
In the event that the battery connection is reversed the unit will not start or operate. The power
2
input socket is fitted with a 15A blade fuse for protection.
● Pulg the 110-120V(100-240V)） with AC adapter.
● Keep pressing the ON/OFF button for 3 seconds to switch the appliance on.
● The display will automatically show the current internal cabinet temperature.
● The power input socket is fitted with a 15A blade fuse for protection.
12/24V DC Power Requirements
If your Fridge/Freezer is cutting out prematurely, it could be due to:
1. The low voltage protection being set too high on the Battery Monitor.
2. DC power cable and/or connections are not suitable to carry the required current. Check the
power cable and all connections and adjust the Battery Monitor on the control panel.
● The Fridge/Freezer is equipped with a multi-level Battery Monitor that protects your vehicle
battery against excessive discharging when the Fridge/Freezer is connected to 12V or 24V DC power
source.
IMPORTANT: When using the Fridge/Freezer with DC power supply, we recommended setting the Battery
Monitor to LOW (L).
NOTE: A battery charger may only be connected to the battery when the Fridge/Freezer has been
disconnected from the DC power source.
● Over-voltage may cause damage to the electronics of the Fridge/Freezer.
● Your Fridge/Freezer is equipped with reverse polarity protection. It protects your Fridge/Freezer against
reverse battery connection and short circuit.
● As a protection for your battery, the Fridge/Freezer switches OFF automatically if the power source
voltage is insufficient.
NOTE: It is important that the correct cable size and gauge is used for the installation of the DC supply
as over distance the voltage can decrease if the incorrect cable size and gauge cable is being used.
●
Always consult a qualified automotive electrician when using a DC extension cable.
Operating your Fridge/Freezer with 110/120V(100-240V) AC
●
Plug the 12V/24V DC power cable into the DC POWER socket (as circled) on the end of the Fridge/
Freezer and then connect to the vehicle cigarette lighter socket or suitable 12V or 24V DC power source.
●
The refrigerator has a memory function. If you do not actively turn off the power, the Fridge/Freezer will
automatically turn on after reconnecting the power, there is no requirement to switch the appliance on.
●
The display will automatically show the current internal cabinet temperature.
●
For optimum performance and efficiency, it is important that the Fridge/Freezer has a reliable DC power
source. It is recommended that connect the battery in directly and reduce the risk of voltage dropping to
the appliance.
●
Use only the 3.5m DC power cable supplied with the Fridge/Freezer.
Operating your Fridge/Freezer with 12/24V DC
04
To Next Page
Loading...
