thepower cable out
Before carrying out any maintenance operation on the refrigerator,take
of its socket.
Should the device fail to work or work badly, before referring to our after-sales service, make sure that:
a) the feeding voltage is not missing;
b) the voltage is the same as the one shown on the plate;
c) the connections and the polarities are right;
d) the airing grids are not covered over;
e) the refrigerator unit is not near any heat source;
f ) the fuse of the feeding line is not blown.
●
Regularly clean the inside and outside of the refrigerator using only warm water and a neutral detergent.
●
Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.
●
Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray detergents,
alcohol, ammonia or abrasive products.
●
If you are not using the refrigerator, we suggest cleaning it well inside and leaving the door ajar
tvenilate the interior.to
Failure to obey the following warnings could result in death or serious injury:
●
ELECTRICAL SHOCK HAZARD. Do not immerse the product in water, or use it in an area that is
excessively muddy.
●
Do not use the cooler for an
y purpose other than as a mobile cooling device.
FALL HAZARD. Do not stand on the cooler. Doing so could damage the unit or cause minor
to moderate injury.
ENERGY SAVING TIPS
Choose a well ventilated installation location which is protected from direct sunlight and allows air
to circulate around the cabinet.
Allow hot food to cool down first before you place it into the cabinet.
Do not open or leave the lid open more often than necessary.
If ice forms on the internal walls or lid defrost the appliance.
Select the desired cabinet temperature in relation to the intended use, avoid setting unnecessarily
low temperatures.
6.MAINTENANCE
7.CLEANING
8.SUGGESTIONS
9.GENERAL SAFETY MESSAGES
07
To Next Page
Loading...
