16
142 x 208 mm
∙ Let the pleated lter dry for about 3 days.
∙ When the parts are completely dry, place the strainer onto the pleated lter. on the strainer and on the pleated
lter must be aligned. Check that they are rmly seated.
Assemble the dust container
∙ While holding the dust container lid by its handle (14), place the motor pre-lter on the bottom of the lid, turn the base
towards and lock it in place.
∙ Replace the dust container lid on the dust container (ensure is aligned with ), then turn the handle (14) towards
and lock it in place.
∙ Fit the dust container (7) into the appliance and lock it in place.
EPA lter:
∙ Clean the lter regularly, particularly under the following conditions:
∙ if the suction power seems to be reduced
∙ before storing the appliance for an extended period, or
∙ before sending to the service centre.
∙ When normally used for household purposes, the lter should be replaced every 6 months.
∙ Open the EPA lter cover (9) and take the lter out.
∙ First tap out the lter and then brush it out. Then tap out any loosened dust residues again.
∙ The EPA lter is not washable.
∙ Put the lter back in and close the cover.
Cleaning
∙ The housing and power cable may not be handled with liquids or immersed in liquids for reasons of electrical safety. Rub
housing with a slightly damp cloth and then dry.
∙ For cleaning, do not use any sharp or scouring cleansers or hard brushes.
Storing the appliance
∙ When not in use, the oor nozzle can be hooked into the park hook holder (10) above the cover of the EPA lter.
Troubleshooting by yourself
∙ To avoid any problems, it is important to empty the dust container regularly and to take this opportunity to check the lters
and clean or replace them depending on how dirty they are.
∙ Before contacting our customer service, check with the help of below table whether you can correct the problem yourself.
To Next Page
Loading...
