17
142 x 208 mm
Switch brush roller for carpet or hard oor
If the front button on the top of the handle is pressed, the rotation speed for the brush roller can be changed. We recommend
fast turning ( ) for carpets and upholstery and slow turning ( ) for hard oors.
Storing the appliance
Convenient stowage function
The appliance can be stored either on the wall bracket or upright in a cupboard or protected corner. To do this, the telescopic
tube must be pushed in completely. Never leave the appliance with the handpiece in a free-standing position in a room or
similar place to prevent it from falling over. An appliance falling over may cause injury or damage to the appliance/battery.
Maintaining the appliance
Emptying the dust container
The dust container can only hold a limited quantity of dirt.
It is therefore best to empty the dust container after every cleaning procedure and if the suction power noticeably drops.
1. Make sure that the appliance is switched off and is not on charge.
2. Take the suction tube off.
3. Press the button button on the side of the dust container. The ap opens and the contents of the dust container can
be emptied.
4. Close the ap.
Cleaning the dust container and motor pre-lter
1. Make sure that the appliance is switched off and is not on charge.
2. Empty the dust container (see chapter ‘Emptying the dust container’).
3. Turn the handpiece over so that the dust container is facing upwards.
4. Unlock and remove the dust container lid by turning it anticlockwise.
5. Unlock the dust container insert anticlockwise ( → ) and remove it.
6. Remove the motor pre-lter from the dust container.
7. Pull the foam cover off the lter and tap it out.
8. Thoroughly tap out and brush off the lter. In doing so, turn the lter material inside out.
9. Brush the dust container insert.
Note: All parts may be cleaned under running water. Make sure that all parts are completely dry before using the
appliance again. The drying time of the lter is about 24 hours.
10.. After complete drying of the individual parts, push the lter cloth into the lter.
11. Pull the foam cover over the lter and place the lter in the dust container.
12. Put the dust container insert over it and lock it in place by turning it ( → ).
13. Place the dust container lid on the hand part and lock it by turning it clockwise until and are facing each other.
To Next Page
Loading...
