10
Blender
Dear Customer,
Before using the appliance, read the
following instructions carefully and keep this
manual for future reference. The appliance
must only be used by persons familiar with
these instructions.
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance.
CE marking
This product complies with all binding CE
labelling directives.
Familiarisation
1. Stopper with measuring cup
2. Lid
3. Blender jug with handle
4. Blender blade
5. Motor housing
6. Rotary control
7. Power cord with plug
8. Blade unit with blender jug
9. Rating label (on underside of
appliance)
Important safety instructions
∙ In order to avoid hazards,
repairs to this electrical
appliance or its power
cord must be carried out
by our customer service.
If repairs are needed,
please send the appliance
to our customer service
department (see appendix).
∙ Before cleaning the
appliance, ensure it is
disconnected from the
power supply and has
cooled down completely.
∙ The appliance should be
cleaned after each cycle of
use.
∙ To avoid the risk of electric
shock, do not clean the
appliance with liquids or
immerse it.
∙ The blender jug, lid and
stopper may be cleaned
with hot soapy water.
∙ For detailed information
on cleaning the appliance,
please refer to the section
Cleaning and care.
∙ Caution: The blades
used in this appliance are
extremely sharp. To prevent
GB
To Next Page
Loading...
Need help?
General
