39
GB
9. Tighten the xing screw.
10. Re-insert the sausage holder (g.10 b). This is done by inserting the
wings of the holder from below into the heating coils. Secure it by tting
the protruding studs on the lifting mechanism into the corresponding
recesses on the holder. Pull the holder downwards and check that it is
rmly seated.
11. Re-insert the cleaning ap.
12. Tighten the xing screw.
WARNING!
Risk of re and burns!
There is an increased risk of re and burns if the
cleaning ap has not been properly secured.
– Ensure that the cleaning ap is properly closed
and securely locked with its xing screw imme-
diately after cleaning.
9.4 If required: cleaning the housing
1. The exterior housing may be wiped with a slightly damp, lint-free cloth.
2. If this is not sufcient, a little mild detergent may be added.
3. Wipe dry with a clean cloth afterwards.
4. If you have removed the grill insert for cleaning, ensure that it is properly
tted again, ie that it has been pushed down all the way and is correctly
seated.
10 Trouble-shooting
10.1 How to solve problems yourself
WARNING!
Risk of injury - The unit does not contain any com-
ponents or parts that can be repaired by the user.
– Caution: Never use a defective appliance!
– Caution: Do not attempt to carry out any repair
work yourself. If a defect is found, contact our
Customer Service Department (see ‚Customer
service‘ on page 44).
Before you contact our Customer Service or send the appliance in, please
use the following table to check whether the problem can be solved at home.
Problem Cause Remedy
The slide
control doesn’t
lock into place
when pushed
down.
The unit is not
connected to
the mains, and
no power is
supplied.
Insert the plug into the socket.
The unit has
overheated.
The display
shows ‚CCCC‘.
Wait for a few minutes; you should
then be able to continue grilling
afterwards.
To Next Page
Loading...
