3
Install the unit on the wall in an upright position; avoid lying down or upside
down. (See Unit Installation Steps on Page 4)
Link the shower head and the water heater with the hose provided.
There are 2 installation methods: single point usage and multipoint usage.
(Refer to Diagrammatic Views on Page 6,7) Note: former option can lower
the possibility of malfunction and extend the life span of unit.
Install No Fuse Breaker (20A/30A/40A/50A) in accordance with amperage
required for the model to prevent electrical overloads.
Install cold water valve and a swing check valve in the supply pipe work to
prevent back flow.
Installation
To comply with Electrical Regulation, it is highly recommended to install Super
Guider’s leakage circuit breaker in switchboard or next to water heater.
Turn on electric supply at the isolating switch.
Power cord entry points are on the top and on the side of the base brim of water
heater unit, which needs to be cut off to extend out the cord.
For first time use after installation, please allow water to flow into water heater
so that the water heater contains water before electricity is connected, at the
same time, it can help to clean impurities from pipe line.
“E”,neutral cord to terminal “N”, live cord to terminal to “L”.
NOTE: the water heater must be earthed.
Route the cords (4mm²/6mm²/10mm² standard cords according to model for
safety purposes) into water heater and connect the earth cord to terminal
To Next Page
Loading...