What to do if the pressure does not rise in my SH Scientific Laboratory Equipment?
If the pressure in your SH Scientific Laboratory Equipment isn't rising, there are a few things to check: * Try pressing the unit for 3 seconds. * Press the AT button for 5 seconds. * Ensure the OVER TEMP value is correctly set. * Verify the Pressure Normalizing Valve is properly closed. * Make sure the lid of the unit is securely closed.
What to do if the temperature does not rise in my SH Scientific SH-AC-60M Laboratory Equipment?
If the temperature in your SH Scientific Laboratory Equipment isn't rising, here are a few possible solutions: * Press the unit for 3 seconds. * Press the AT button for 5 seconds. * Check the OVER TEMP set value.
What to do if the operating temperature fluctuates on SH Scientific SH-AC-60M?
If the operating temperature of your SH Scientific Laboratory Equipment fluctuates, try pressing the AT button for 5 seconds.
Set the target temperature for operation. Press MODE for 3 sec to exit or 1 sec to move to TIME mode.
Set the desired operating time. Press MODE for 3 sec to exit or 1 sec to move to BEEP mode.
Set the duration of beeping after operation. Press MODE for 3 sec to exit or 1 sec to move to TEMP mode.
Press button for 3 sec to start the unit running with lamp ON. Ensure correct button press for operation.
The unit stops when TIME mode ends or is manually stopped. Normalize pressure or open valve if needed.
Recommended for temperature fluctuations or failure to reach set temp. Enter/quit by pressing AT button for 5 sec.
Check heater output by clicking AT for 1 sec. Check remaining time by clicking AT again.
General| Model | SH-AC-60M |
|---|---|
| Capacity | 60L |
| Controller | Digital PID Controller |
| Outer Material | Powder Coated Steel |
| Temperature Accuracy | ±1°C |
| Inner Material | Stainless Steel |
| Shelves | 2 |
| Power Supply | 220V, 50Hz |
To Next Page
