Shadow x2 - Step I Perform an Audio Battery Test; Step 2 Adjust the SENSITIVITY Control; Step 3 Perform an Air Test in Discriminate Mode

36 pages

To Next Page

To Previous Page

GETTING STARTED 13

Step 1: Perform an Audio Battery Test

♦

Turn the SENSITIVITY control from POWER OFF to 1

You will hear the battery test tone for a few seconds as the battery is automatically

tested. When the tone stops, the detector is on and the controls are ready for adjusting.

Function Demonstrated: How the battery test tone will tell you the battery is working

each time the detector is turned on.

Step 2: Adjust the SENSITIVITY control

♦

Turn the SENSITIVITY control from 1 to 8

This is a good setting to begin with each time you use your detector.

Leave the control at this setting for the rest of QuickStart.

Function Demonstrated: Where to set the SENSITIVITY control for basic detector

operation.

Step 3: Perform an air test in Discriminate Mode

Identify the Target Response

Use Discrimination

Operate the QuickCheck Pinpoint feature