Shaq Air Fryer 6- & 7-Quart 15
Troubleshooting
Symptom Possible Cause Solution
The appliance does not work
The appliance is not plugged in. Plug the Power Cable into a wall outlet.
You have not turned the appliance on by setting the
preparation time and temperature.
Press the Power Button. Select a time and
temperature. Press the Power Button again and
cooking will begin.
You have probably turned off the appliance. If you
press the Power Button while the appliance is
cooking, you will trigger the Auto Shut-Off mode.
Press the Power Button. Select a time and
temperature. Press the Power Button again and
cooking will begin.
Food is not cooked
The basket is overloaded. Use smaller batches for more even frying.
The temperature is set too low. Raise temperature and continue cooking.
Food is not fried evenly
Some foods need to be shaken during
the cooking process.
See the “Shaking” section in
“Instructions for Use.”
The basket will not slide
into appliance properly
The basket is overloaded.
Do not ll the basket above the
Maximum line.
The Fry Basket is not placed in the
Outer Basket correctly.
Gently push the Fry Basket into the Outer
Basket until it clicks.
White smoke
coming from appliance
Too much oil is being used. Wipe down to remove excess oil.
The basket has grease residue from the
previous operation.
Clean the basket after each use.
French fries are
not fried evenly
Potatoes are not prepped properly. Consult a recipe for potato type and prep.
Fries are not cut evenly. Cut fries thinner or reshape fries.
Fries are too crowded. Spread fries out or cook a smaller batch.
Potatoes are not rinsed properly during preparation. Pat dry to remove excess starch.
Fries are not crispy Raw fries have too much water.
Dry potato sticks properly
before misting oil.
Cut sticks smaller.
Add a bit more oil.
Error
E1 - Broken circuit of the thermal sensor
Call Customer Service at
1-973-287-5113
E2 - Short circuit of the thermal sensor
To Next Page
Loading...
