Shark Ninja Master Prep Professional - Using the Ninja Master Prep Professional Bowl

10 1-877-646-5288
WARNING: DO NOT try to place the Chopping
Blade Assembly onto the Power Head and then
into the Master Prep Professional Bowl.
Using the Ninja
®
Master Prep
®
Professional Bowl
1 Place the Master Prep Professional Bowl on a clean,
dry, level surface.
2 Holding the Lower Chopping Blade Assembly by the
shaft, place it over the spindle pin inside the Master
Prep Professional Bowl. (fig. 1)
3 Carefully insert the Upper Chopping Blade Assembly
over the Lower Chopping Blade Assembly rotating it
until it locks onto the Lower Chopping Blade Assembly.
(fig. 2)
IMPORTANT: Always assemble the Chopping
Blade Assembly inside the container.
Shaft
Fig. 1 Fig. 2
WARNING: Never leave the appliance unattended while in use.
WARNING: Remove utensils prior to processing.
WARNING: DO NOT crush ice in Master Prep Professional Bowl or damage may occur to the unit.
CAUTION: Handle the Chopping Blade Assembly with care, as the blades are very sharp.
CAUTION: Blade assembly is loose and not locked in place. Make sure to remove the Chopping Blade
Assembly before emptying contents of processor bowl.
CAUTION: Do not blend hot liquids.
IMPORTANT: Make sure that the Power Head is plugged in for use.
IMPORTANT: Never run the appliance empty.