11
A-1
B-1
C-1
REMOVAL
A/ Removal
- Move the sun shield to the lower position
- Move the sun visor as indicated by the ar-
row to release the hook (Fig. A1).
- Pull the sun shield delicately downward
and unclip the sun shield at
the sides on each side (Fig. B1-C1).
REPLACEMENT
Carry out the previous operation in reverse
order:
- Move the handling button to the lower
position.
- Clip the sun shield on at one side and then
the other (Figs. A1–B1).
- Using a screwdriver or similar pointed
instrument, apply pressure to the central fixing
button and then clip the sun shield back on
by lifting it slightly (Fig. C1).
SUN SHIELD
REPLACE
WARNING! This sun visor can-
not be used when the light is
strong and you ride in an area where
you may have a sudden change in
visibility (ex tunnel). In all cases where visi-
bility is reduced, the beginning or end of the
day, night, rain or fog, the sun visor must be
set high to not to degrade your vision.
WARNING! If your visor and/or
sun shield no longer provides you
with clear visibility, you must immediately
replace it. Never ride if your sun shield is
scratched, dirty, foggy or with your vision
obscured in any way. Always ride with per-
fect visibility. Never ride with the sun shield
as eye protection. You must always ride with
the visor in the lowered position.
WARNING! If you are not sure that
you properly replaced the sun shield,
do not use the helmet. The sun shield
could suddenly and without warning become
detached from the helmet while riding, cau-
sing you to lose control of your motorcycle,
resulting in an accident, personal injury, or
death. Contact your retailer for any assis-
tance or advice.
To Next Page
Loading...
Need help?
General
