9www.sharkninjamanuals.co m
USING THE FLAT SCRUBBER
Cleaning Tip: The Flat Scrubber is designed for cleaning
a variety of surfaces and is exceptional on those that
are large and flat including counter tops, table tops,
walls mirrors, windows, stairs, shelves and other similar
surfaces. Super absorbent microfibre bonnet loosens,
lifts, and locks in dirt and grime while sanitising at the
same time.
1 To attach the All-Purpose Scrubber Bonnet, place
the bonnet exterior side down on a flat surface
(lavender tab indicates the bottom of the bonnet)
and insert the top of the Flat Scrubber Tool into the
top portion of the bonnet and then pull the bonnet
over each side of the back edge.
2 Attach the Flat Scrubber Tool by snapping into the
Accessory Hose until it clicks into place. (fig. 15)
3 Press the power button to start steaming.
4 To remove the Flat Scrubber Tool, press and hold
down the Accessory release button. Then slide out
the Flat Scrubber Tool.
CAUTION: Turn the unit off before attaching or
removing the Flat Scrubber Tool.
CAUTION: Do not use the Flat Scrubber Tool without
the All-Purpose Scrubber Bonnet attached.
USING THE WINDOW SQUEEGEE
Cleaning Tip: To use the window squeegee, work with
the vapor jet down using top to bottom movements. To
do this without leaving streaks, use lateral movements
from the top to the bottom of the surface.
CAUTION: Always avoid any sudden changes
in temperature to prevent breakage of cracks in
windows.
1 Attach the Window Squeegee by snapping into the
handle of the Accessory Hose until it clicks into
place. (fig. 14)
2 Press the power button to start steaming.
3 To remove the Window Squeegee, press and hold
down the Accessory release button. Then slide out
the Window Squeegee.
CAUTION: Turn the unit off before attaching or
removing the Window Squeegee.
fig. 14 fig. 15
To Next Page
Loading...
Need help?
General
