11www.sharkninjamanuals.co m
USING THE WEDGE CLEANING TOOL
Cleaning Tip: The Wedge Cleaning Tool was designed for
cleaning a variety of surfaces and is exceptional on those
that are large and flat, both horizontal and vertical. Broad
cleaning sides and super absorbent microfiber fabrics
loosen, lift, and lock in dirt and grime while sanitising at
the same time.
The wedge tip and squared edges reach into tight areas
often missed or difficult to reach with traditional cleaning
methods. The Wedge sides concave to wrap around sink
and faucet fixtures, door knobs, and other small curved
surfaces leaving them clean all around. Multiple sides
provide more surface cleaning area and allow one to
clean with one side and finish with the other. Surface
examples for use are countertops, tabletops, cabinets,
walls, floor spot cleaning, bathroom fixtures and more.
1 Slide the Wedge All-Purpose Pocket over the Wedge
Cleaning Tool frame until it is completely on. (fig. 19)
2 Close the cinch by pulling on the elastic band and
sliding the locking bean to tighten. (fig. 20)
3 Attach the Wedge Cleaning Tool by snapping into
the handle of the Accessory Hose until it clicks into
place. (fig. 21)
4 Press the power button to start steaming.
5 To remove the Wedge Cleaning Tool, press and hold
down the Accessory release button. Then slide out
the Wedge Cleaning Tool.
CAUTION: Turn the unit off before attaching or
removing the Wedge Cleaning Tool. Always use the
Wedge Cleaning Tool with a pocket attached.
CAUTION: It is recommended that you allow the
cleaning pockets to cool off before removing them
from the Wedge Cleaning Tool to avoid possible
scalding injury.
fig. 21
fig. 20fig. 19
To Next Page
Loading...
Need help?
General
