6
Freephone: 0800 862 0453
10
Using the same back and forth motion, continue
to go over the same area without spray. For
heavily soiled high traffic areas or dingier carpets
you may need to go over the area for several
minutes, spraying periodically. Spray more
solution as needed while cleaning. Repeat as
necessary until the entire carpeted area has been
cleaned. No rinsing is required.
11
If the Reusable Bottle is empty, you can refill
it at any time as long as the
Sonic Duo
™
is
unplugged from the outlet.
12
Once finished, step on the tag of the
Carpet
Scrub‘n Stain
™
Pad and lift the unit to remove
the
Carpet Scrub‘n Stain
™
Pad from the
Sonic Duo
™
(Fig. 21). Let the carpet dry
thoroughly and then vacuum.
6 Screw the bottle cap on tightly and insert the
Reusable Bottle into the unit. Push it down to
make sure that it is well inserted. You will hear
an audible “Click” when the Reusable Bottle is
inserted properly. (Fig. 17)
7 Twist the quick cord release holder to unwrap
the power cord completely. (Fig 18) Plug into an
electrical outlet and slide the “ON/OFF” button
to turn the Sonic Duo
™
on. Select the faster
Carpet Mode (II). (Fig 19)
8 Lightly step on the back of the scrubbing head to
release the handle.
WARNING: Never stand on the Sonic Duo
™
.
9
Begin cleaning by pressing the Spray Button to
apply the cleaning solution to the carpet that
is to be cleaned. (
Fig. 20
) Spray the solution
continuously while pushing the unit forward and
then pulling it backward several times until the
area to be cleaned is damp.
NOTE: The first time that you use the
Sonic
Duo
™
there may be air in the system causing a
delay for the solution to come out of the spray
nozzle. Hold the spray button down for 5 to 10
seconds until you see the solution spray out.
fig. 17
fig. 18
fig. 19
fig. 20
fig. 21
Using Your Sonic Duo
™
Carpet, Wood & Hard Floor Cleaner - cont.
To Next Page
Loading...
Need help?
General
