4
Freephone: 0800 862 0453
fig. 9
fig. 6
fig. 8
fig. 7
IMPORTANT: Always check with the carpet
manufacturer or distributer before using the
Shark
®
Activating Pretreater Stain & Odour
Remover or the Low Moisture -No Rinse - Carpet
Cleaner. To determine the colorfastness of any
carpet -especially with reds or blues - take a
clean, moist towel and gently rub a small area in
an inconspicuous area. If color comes off on the
towel, you should discontinue use.
Using Your Sonic Duo
™
Carpet, Wood & Hard Floor Cleaner
fig. 10 fig. 11
Cleaning Your Carpets
The Sonic Duo
™
comes with a Reusable Bottle with
a “Purple” cap and label. This bottle is to be used
with the Low Moisture –No Rinse- Carpet Cleaner.
The Sonic Duo
™
also has a second Carpet Mode (II)
that should be used when cleaning carpets. Please
note that not all carpets react to the Sonic Duo the
same way. Some carpets will require more time and
cleaning solution than others.
REGULAR CLEANING
Step 1:
1 Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in the carpet.
Step 2:
2 Attach the Carpet/Rug Cleaning Pad to the
bottom of the Sonic Duo
™
. This pad has a
“Purple” trim and tag that says Carpet/Rug
Cleaning Pad. Attach the pad as shown in
(Fig. 6) – the tag should be positioned toward
the back of the Sonic Duo
™
.
3 Remove the Reusable Bottle by holding it and
pulling up (Fig. 7). Remove the cap by turning it
counterclockwise.
4 Fill the Reusable Bottle with the “Purple” trim
and label with water until the “1:7 Water” fill
line and then with the Low Moisture –No Rinse-
Carpet Cleaner until the “Solution” fill line.
(Fig. 8)
Always fill with water first and then add the
cleaning solution so to avoid foaming and
ensure accuracy when measuring.
5 Screw the bottle cap on tightly and insert the
Reusable Bottle into the unit. Push it down to
make sure that it is well inserted. You will hear
an audible “Click” when the Reusable Bottle is
inserted properly. (Fig. 9)
6 Twist the quick cord release holder to unwrap
the power cord completely. (Fig 10) Plug into an
electrical outlet and slide the “ON/OFF” button
to turn the Sonic Duo
™
on. Select the faster
Carpet Mode (II). (Fig 11)
To Next Page
Loading...
Need help?
General
