12
Freephone: 0800 862 0453
General Tips:
• Change the Wood & Hard Floor Cleaning Pad frequently for best results.
• Always vacuum floors and carpets before cleaning or polishing.
• If you notice any uneven areas or streaking, DO NOT go over the same area with more polish if the floor
has begun to dry. Wait until the floor polish has totally dried for approximately a day before going over it
again with more polish.
• Never lift the Sonic Duo
™
up at the end of a section of flooring that has been polished. Always slide the
unit off the floor and then remove the pad.
• When polishing, you should always leave each section looking wet, never dry, before going to the next
section.
• Try the Pretreater Carpet Stain & Odour Remover to eliminate your toughest stains. Just spray the solution
onto the stain until saturated, allow 5-10 minutes to set and then blot up the stain with a white cloth or
towel. Never scrub the stain, only blot.
Pad Consumption
Hard Floor Cleaning Pad Replace after 20 washes
Hard Floor Polishing Pad Replace after 20 washes
Carpet/Rug Cleaning Pad Replace after 20 washes
Carpet Scrub ‘n Stain
™
Removal Pad Replace after 20 washes
Cleaner Consumption / Usage
Wood & Hard Floor Cleaner
Use 1.0 L diluted solution per 55 m
2
Wood & Hard Floor Polish Use
0.8 L
solution per
40 m
2
Activating Pretreater Carpet
Stain & Odour Remover
Fully saturate a spot or stain before blotting
Low Moisture - No Rinse -
Carpet Cleaner
Use
1.0 L
diluted solution per 25 m
2
Using Your Sonic Duo
™
Carpet, Wood & Hard Floor Cleaner - cont.
To Next Page
Loading...
Need help?
General
