Why is my Shark Ultrasonic Jewelry Cleaner leaking liquid?
If your Shark Ultrasonic Jewelry Cleaner is leaking, the dirty water tank may be overfilled. Ensure that both the dirty water tank and the Deep Clean Pro Tank are installed correctly. Also, ensure the float valve in the dirty water tank is not stuck and that the unit is on a stable, flat surface.
What to do if my Shark Ultrasonic Jewelry Cleaner unit is not turning on?
If your Shark Ultrasonic Jewelry Cleaner isn't turning on, ensure it is completely plugged in. If it is, try a different socket. Also, double-check that you've pressed the On/Off button.
Why does my Shark Ultrasonic Jewelry Cleaner have low or no suction?
If your Shark Ultrasonic Jewelry Cleaner has low or no suction, ensure the dirty water tank isn't overfilled and is correctly installed. Check the clog access point underneath the unit and clear any debris trapped inside at the end of the hose. If a cleaning tool is attached, make sure it's connected correctly, and remove any debris from the cleaning attachments.
How to fix solution tanks leaking on Shark Ultrasonic Jewelry Cleaner?
To fix leaking solution tanks on your Shark Ultrasonic Jewelry Cleaner, ensure the caps on the solution tanks are tightened fully. Also, make sure both tanks are installed correctly and the caps have clicked into place.
What to do if Shark Ultrasonic Jewelry Cleaner has inconsistent spray or no spray?
If your Shark Ultrasonic Jewelry Cleaner has inconsistent or no spray, ensure there is cleaning solution in both of the solution tanks. Make sure the Deep Clean Pro Tank is installed correctly and that the unit is plugged in and the power is on.
General| Brand | Shark |
|---|---|
| Model | StainStricker PX200 Series |
| Category | Ultrasonic Jewelry Cleaner |
| Language | English |
To Next Page
