6 TOLL FREE: 1-800-798-7398
ASSEMBLY OF YOUR FLOOR
AND CARPET SWEEPER:
1 Slide the upper pole (the tube
with the handle) into the end
of the Shark
®
Backsaver
™
joint
that has a small notch in it (a).
Then slide the lower pole into
the other end of the joint (b).
Push it in until it clicks into
place. (fig. 1)
COMPONENTS:
A Floor and Carpet Sweeper Base
B Speed Control Button
C On/Off Button
D Upper Pole with Handle
E Backsaver
™
Release Button
F Shark
®
Backsaver
™
Joint
G Lower Pole
H Dust Cup Empty Lever
I Charging Adapter
Fig. 1
Fig. 2
Model Number: V2950 32
Voltage: 7.2 V
AS SE M B LY
B
E
H
C
A
D
F
G
I
2 Insert the Shark
®
Backsaver
™
folding handle you just
assembled into the base. You
should hear the locking tab click
into place. (fig. 2)
IMPORTANT: You must charge
the batteries for 7 hours before
using the floor and carpet
sweeper for the first time.
See page 8 for instructions on
charging your unit.
a
b
To Next Page
Loading...
