sharkclean.comsharkclean.com
NOTE: All accessories are compatible with both the wand and the handle.
WHOLE-HOME CLEANING
CLEANING MODES
To engage brushrolls, step on floor nozzle
and tilt handle back.
Press power button to turn on vacuum.
Please note the brushrolls will not spin
unless the wand is reclined.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushrolls are spinning and working as they should.
Solid Red: There is a jam in the brushroll area. Turn o the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn o the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
Press the Wand Release button to detach the
wand from the pod.
Thick Carpet & Area Rug Cleaning
Slide the surface switch to the top position
to select Thick Carpet/Area Rug.
Carpet & Low Pile Cleaning
Slide the surface switch to the middle position
to select Carpet/Low Pile to increase the
speed of the brushrolls and to help remove
stuck-on dust and debris.
Hard Floor Cleaning
Slide the surface switch to the bottom
position to select Hard Floor.
With pod removed, press the Wand Release
button to detach the wand from the floor
nozzle.
Press the Handle Release latch to detach the
handle from the wand.
Press the Lift-Away button to detach the pod
from the floor nozzle.
UPRIGHT
POWER SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—HANDLE
POWERED LIFT-AWAY®
ABOVE-FLOOR—WAND
SURFACE SELECTOR
LIFT-AWAY®
WHOLE-HOME CLEANING
SETTINGS
BRUSHROLL INDICATOR LIGHT
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please set to Carpet/Low Pile.
NOTE: For maximum suction for above-floor cleaning per ASTM F558, set to Hard Floor mode.
NOTE: Try using Hard Floor mode for low pile area rugs.
To Next Page
Loading...
Need help?
General
