sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, press release button on
top of the pod. Tilt dust cup away from wand,
then lift to remove.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To remove collected debris from Lint Screen,
press top release button and lift handle to
access screen.
CLEAN HEPA FILTER EVERY YEAR
With the dust cup removed, press button on Filter Door. Pull forward and slide out to remove,
then take out HEPA Filter.
To reinstall, insert HEPA filter into unit and replace filter door.
CLEAN PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to
maintain your vacuum’s suction power.
To prevent damage from cleaning chemicals,
rinse filters with cold water only. Allow all
filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being
drawn into electric parts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when
cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Filter
Door
Release
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
Filter
Filter Door
To Next Page
Loading...
Need help?
General
