Sharkline S-Pool - Assembling the Pool Wall; Putting Up the Pool Wall

04
Pu ng up the wall
IMPORTANT NOTE:
If you use a skimmer, you should consider pu
ng the pre-punched slots not too far
from the planned loca
on of the Įlter. If you don’t use a skimmer, the pre-punched holes
must be covered with heavy fabric tape. This prevents the lining from being cut.
the pool wall: plywood, some extrĂƐĂŶĚŽƌĮŶĞĚŝƌƚto make the cove, the liner and a ladder
Make sure the skimmer and water return holes are located where you need them to be.
Unpackage the coiled pool wall and stand it on the plywood at the place close to where
you need to install skimmers. (image 8)
(image 9)
Set lengths of stabilizer onto the top ledge of the wall as you uncoil it.
DO NOT SKIP THIS STEP! Otherwise you might
end up with a slightly oval shape, which can cause problems later on. (image 7)
ASSEMBLING THE POOL WALL