05
TYPE 2 – bead/snap bead liner
With a snap bead liner you should have received a beaded liner track
(referred to as a “coping bead receiver”). (image 22)
The beaded liner track should be installed onto the pool wall all of the way around the pool. These
pieces should be as close together as possible. Leaving spaces between bead tracks can cause liner
problems later on.
Once all of the beaded liner track is on the wall, you can snap the liner bead into the beaded liner track
at four random points around the pool. A
er that is done, and you are sa sĮed with how the liner is
situated within the pool, you can con
nue snapping the remainder of the liner into place around the
pool.
Go around the en
re pool again making certain that the liner is securely snapped into the track. This is
important to conĮrm so that the liner does not pull out
while under pressure of being Įlled with water.
Go around the liner pool again making certain that the liner is securely snapped into the track. This is
important to conĮrm so that the liner does not pull out while under the pressure of being Įlled with
water.
INSTALLING THE LINER
To Next Page
Loading...
