05
TYPE 3 – hung/J or V-bead line
The top of the wall of the liner has what is called a “V-Bead” welded onto it. Simply open up the
bead with your Įngers and hang it directly on top of the pool wall. (image 23) When this is done
properly, the only por
on on the outside of the pool wall is approximately 1” of the V-Bead.
No printed liner material is actually going over the top of the wall to the outside of the wall.
Make sure the bead is on evenly around the en
re pool, and that the liner is hanging straight down
from the top of the wall. The liner should not have creases in it, if there are creases it is because
Make the necessary adjustments before proceeding.
IMPORTANT NOTE:
Some liners may Įt very
ghtly, it is be er to install uprights, top plate and rail
before going onto next step.
IMPORTANT NOTE:
Do not trim oī the excess liner. (if the liner ever needs to be removed, trimming the
liner will make re-installa
on very diĸcult.) Instead, roll up any excess liner and tape
it in place near the top of the wall.
INSTALLING THE LINER
To Next Page
Loading...
