7
26SL41M, 26SL71M
29SL81M
SERVICE
NUMBER
DATA
ADJUSTMENT CONTENTS
ADJUSTMENT ITEM
RANGE
INITIAL VALUE
S01 PICTURE 55 00-7F
S02 TINT 46 00-7F
S03 COLOR 32 00-7F
S04 BRIGHTNESS 40 00-7F
S05 SHARPNESS 28/24 00-3F
Must be set to "28"(26SL41M/71M)/"24"(29SL81M)
S06 VERTICAL PHASE 00 00-07 Must be set to "00"
S07 HORIZONTAL PHASE 12 00-1F
S08 RF-AGC 23 00-3F
S09 VERTICAL AMP 20 00-3F
S10 PIF VCO 2C 00-7F
S11 R CUT-OFF 00 00-FF
S12 G CUT -OFF 00 00-FF
S13 B CUT-OFF 00 00-FF
S14 G GAIN 7F 00-FF
S15 B GAIN 7F 00-FF
S16 TRAP 00/01 00 or 01
Must be set to "00"(26SL41M/71M)/"01"(29SL81M)
S17 BALANCE 20 00-3F Must be set to "20"
S18 C.C. POSITION 17 00-7F
S19 MUTE 00 00,01,03 "00"=Normal, "01"=No Y, "03"=No Vertical
S20 ENERGY SAVE OFFSET 20 00-3F Must be set to "19"
S21 INT. CYCLE TIMING 7A 00-1F Must be set to "7A"
S22 00 00 No Setting
S23 TUNER SETUP 00 00, 01 Must be set to "00"
OP1 OPTION (Set to each model) 00 00-FF
Must be set to "E1"=26SL41, "E7"=26S71M, 29SL81M
OP2 OPTION (Set to each model) 00 00-FF Must be set to "0C"=26SL41M, "0F"=26SL71M,
"8F"=29SL81M
M01 INPUT LEVEL 0A 00-0F
M02 ST VCO 20 00-3F
M03 FILTER 1C 00-3F
M04 WIDE BAND 20 00-3F
M05 SPECTRAL 1B 00-3F
NECESSARY
UNNECESSARY
ADJUSTMENT
NOTES
PART REPLACED
IC2001
IC2101
X
IC3001
X
CRT
X
IC201 X
X
Data is stored in IC2101.
The adjustment is needed to compensate for characteristics
of parts including IC201 and MTS level (M01).
Holding down both the CH-up/down buttons on the TV set in
the service mode for more than 2 seconds will automatically
write the above initial values into IC2101. Then perform a
complete adjustment.
Adjust items related to picture tube only.
Adjust items related to MTS only (M01~M05).
Holding down both the CH-up/down buttons on the TV set at service mode for more than 2 seconds will automatically
write the above initial values into IC2101.
Table - A
Table - B
Only for Models
26SL71M, 29SL81M
To Next Page
Loading...
