Sharp AE-X095E - Timer Operations; Timer Off Function

TIMER OPERATION
NOTE:
Before setting the timer, check to see if the current clock time is properly set.
TIMER OFF
1 Press the TIMER OFF ( ®>0 ) button.
2 The TIMER OFF indicator will blink; press the TIME
ADVANCE or REVERSE buttons to set the desired
time. (The time can be set in 10-minute units.)
VY o1adA 3 Point the remote control at the receiver window of
CIE
TL)
the
unit
and
press
the
TIMER
SET
(SET/C)
button.
FULFOWER
SrO1H
¢
The
yellow
TIMER
lamp
on
the
unit
lights
up-
Al ¢ A beep will sound when the unit receives the
COBO
of || 9 signe
SETIC fori) |
TIPS ABOUT TIMER OFF OPERATION ( TO CANCEL TIMER MODE
When
the
TIMER
OFF
mode
is
set,
the
room
Press
the
TIMER
CANCEL
(SET/C)
button.
temperature
is
automatically
adjusted
to
pre-
¢
The
yellow
TIMER
lamp
on
the
unit
will
vent
the
room
from
becoming
too
hot
or
too
go
out.
cold
while
you
sleep.
(Auto
sleep
function)
¢
The
current
clock
time
will
be
displayed
on the remote control.
COOL/DRY MODE:
¢ One hour after the timer operation has
begun, the temperature rises 1°C higher
than the thermostat setting.
HEAT MODE:
¢ One hour after the timer operation has NOTE:
begun, the temperature drops 3°C lower
than
the
thermostat
setting.
*
If
you
combine
the
use
of
the
ON
and
OFF TIMERS, both TIMERS will be
canceled.
NOTE:
Auto sleep function will not activate during c TO CHANGE TIME SETTING _)
the FAN ONLY mode.
First, cancel the TIMER, then set it agan .
E-9