CLEANING AND MAINTENANCE
1.
2.
3.
Grille
Air filter
Air filter
Grille
WARNING : Turn off and unplug the unit before performing any cleaning or
                    maintenance.
CLEAN THE FILTER
To remove dust from the filter,  use  a
vacuum cleaner  or wash it with water.
If the filter is very dirty, wash it   with
detergent and rinse carefully  with water.
Dry  the filter with a soft cloth. Do not
expose  the filter   to  heat  or  dry  it  under
direct sunlight.
CLEANING THE FILTER
Remove the grille by sliding it to the left
until it stops and then pull it towards you.
Then lift and unhook the bottom of the air
filter and remove it.
REMOVE THE FILTER
If the filter  is  clogged  with  dust the  amount  of air flow will be reduced, resulting  in  poor
cooling performance. The filter should  be  cleaned every 10 days. At the beginning of every
cooling season or if the air conditioner has not been used for a long period, clean  the  filter
before starting to operate the unit.
REINSTALL THE FILTER
Fit the top hooks, and then hook the
bottom of the air filter.  Replace the grille.
Never operate the unit without installing
the filter and the grille.  It may result in
serious damage to the unit.
CLEANING OF THE FRONT PANEL,GRILLE AND CABINET
   OILING OF THE COMPRESSOR AND FAN MOTOR IS UNNECESSARY
The compressor is permanently lubricated and is hermetically sealed. The fan motor is
lifetime sealed and does not require oiling.
To clean the front panel, grille and cabinet, wipe with  a  soft,  dry
cloth  or  with  a  cloth  moistened with a mild soap. Rinse carefully
by wiping with a damp cloth and dry completely.
Avoid splashing the unit with water. Excessive water will affect
electrical insulation  and  fire may be resulted during operation.
The grille can also be 
removed and be washed with water and soft
sponge or cloth.  If mild soap should be used, rinse carefully with
water.  Dry the grille completely in the shade and reinstall it.
Never use erosive chemicals or abrasive cleaners on any  part  of
the  unit.  To  avoid  damaging the unit, do not use hot water of over
50°C when cleaning.